Wheelchair Loading

Check this video out to see just how fast and easy it is to load your wheelchair....this video last about one minute. That's how long it takes!

---

Now there is a special design for Top End Force2 and ForceG handcycles.  Check out Tyler in the video below.

For some Top End Force bikes, the WBs have been made longer to compensate for the seat angle bar that extends outside of the rear axle of the bike.  When ordering, simply select the WB2 type and put in your type of handcycle and we will send you the correct one.

Freedom Ryder, Top End, Quickie, Lightning, and more...

Limitations:
For most handcycles, the Wheelchair Buddies system works.  So far, sets have been sold to users of Freedom Ryder, Top End, Quickie, Lightning, Intrepid and Varna.  However, they will not work with every setup.  Some measurements will need to be made to ensure compatibility.  If unsure, feel free to contact us through the contact form and we'll help you out.  In some cases, the WBs can even be specially made to fit your setup! 

The biggest restriction is that the frame of your wheelchair needs to fit in between the rear wheels of your handcycle.  To measure this, simply remove the wheels from your wheelchair (they will be stacked on top of the setup) and measure the width of your frame.  Next, measure the narrowest distance between the rear wheels of your handcycle.  If the width of your wheelchair frame is less than the width between the rear wheels of your bike, you should be good to go.

WB1 Instructions:

WB2 Instructions: